Exactly how to Use a Miter Saw

[Shofner Cyndy]

A miter saw is the device for tasks that require precise lumber and moulding cuts-- particularly angles. The device named for cutting miters does so much a lot more.

Sorts Of Miter Saws

With a board flat on the base of a miter saw, any tilted cut across the vast face counts as a "miter" on any miter saw. Transform the board on its edge, location it against the fence, and also you'll cut a "bevel." A lot of saws reduced from 90 to 45 levels in both instructions, and some saws can reduce up to 55-degree angles.

Saws start to differ when you check out their blade size-- commonly 10 inches or 12 inches. The larger the blade, the deeper and larger its maximum cut. Generally, a 10-inch miter saw will certainly reduce a 2 x 6 at 90 levels and a 2 x 4 at 45 levels; a 12-inch miter saw will cut a 2 x 8 at 90 levels and also a 2 x 6 at 45 degrees.

Saws likewise vary by whether the blade arm simply rotates (a standard miter saw) or both swings as well as slides (a moving miter saw). The gliding activity can reduce also bigger boards. A 12-inch variation, for instance, will reduce a 2 x 16 at 90 degrees and also a 2 x 12 at 45 levels.

Either can come to be a substance saw-- the blade arm both swings at an angle as well as turns at an angle to the bed of the table to cut both a bevel and also miter at once. This is primarily used to cut crown moulding.

Reducing with a Miter Saw

The cut angle as well as timber thickness establish where the blade will certainly call the product. When noting a board, prolong the line across the stock, drop the blade to the timber to inspect your positioning, and also adjust the board as needed prior to beginning the saw.

When you're cutting a board, remainder over half its size on the saw. If the board is too long, stack a couple of scraps alongside the saw to support the overhanging board. For a timesaving service, install your saw on a saw stand with assistances for long stock.

Location the supply against the fencing at the back of the saw base, as well as hold it with your hands (or a clamp) at least 6 inches from the blade. Never cross your arms when running the saw.

Begin the saw at the top of the operating setting, enable the motor to find up to speed, and bring the saw down right into the timber. When the board is cut right through, release the trigger as well as enable the blade to totally stop before you increase the blade.

Learn the kinds of cuts you can make with a miter saw. Enjoy our DIY Essential video:

2 Time-Savers

You can accelerate recurring cuts in 2 ways: Instead of independently determining parts for identical routes, note the part size on an item of masking tape connected to the fencing. Then eliminate the tape when you're done.

With the saw unplugged as well as the blade down, procedure from the blade teeth to a point on the fence equal to the component size.

With the end of a board pushed lightly versus the block, make your cut. Each component you cut after that will be the same size-- simply blow away any type of sawdust that can pile up against the stop block.

Quick Tips for Miter Saw Success

• Always reduced the manufacturing facility end from a board prior to measuring and also cutting a part for far better fit and much less sanding.

• Allow the saw do the job; don't require the blade with the wood.

• More teeth equates to smoother cuts. Make use of a blade with more than 50 teeth for building and construction cuts. For great cuts, such as moulding, utilize a blade with greater than 90 teeth.

• Dealt with lumber typically has a higher moisture material than building and construction lumber, so make use of a reduced tooth matter even for fine cuts. The open rooms between the teeth get rid of the particles as well as placed much less stress on the motor.

• Preferably, cut one angle end of a component before you mark as well as reduce the contrary end.